Operating Procedures - ITC SPT110 Manuel De L'utilisateur

OPERATING PROCEDURES

OPERATING THE CHUCK
1. Connect the drill to 120 volt power.
2. Move the forward / reverse switch (H, functional description, above) to the
3. Grasp the chuck tightening ring (B, functional description, above) to prevent it
4. Gently press the trigger.
5. This will open the chuck, until it accepts the drill bit or accessory shaft, up to
6. To close the chuck and tighten it, move the forward / reverse switch to the
7. Grasp the chuck tightening ring to prevent it from turning when the drill turns.
8. Gently press the trigger.
9. This will close the chuck, and tighten the jaws' grip on the bit. When the
If there is no power available, the chuck can be opened and closed manually by
turning the chuck tightening ring and holding the chuck stop ring (C, functional
description, above) against each other.
ROTATION DIRECTION
1. To change the chuck rotation direction,
2. Move the rotation direction switch above the trigger to the other side.
= Setting the direction switch to the left causes the drill to turn clockwise, for
= The direction switch moved to the right will cause the drill to run in reverse
RUNNING THE DRILL
1. Plug in the tool.
2. Hold the tool firmly. Squeezing the trigger more will increase the speed.
3. To maintain the speed, engage the Trigger lock-on button (E, functional
4. To disengage the Trigger lock-on button, squeeze the trigger.
WARNING! Turn off your drill at once, unplug and inspect it for serious
problems if:
=
!
=
=
=
FOR PROPER OPERATIONS
„
„
!
WARNING! If the drill stops suddenly, release the trigger switch immediately
and remove the drill from the work to determine the cause.
„
„
right; the reverse position.
from turning when the drill runs.
3/8" (10 mm) in diameter.
left, the forward setting.
Chuck tightening ring begins to slip in your fingers, the jaws are tight.
normal drilling and driving screws.
(counterclockwise) direction, backing drill bits and screws out screws out of
their holes.
description, above) on the left side of the handle when squeezing the trigger
switch. You can then release the trigger while the tool continues to run at
speed.
Moving parts get stuck
Speed drops to an abnormally low level
The motor housing gets hot
Sparks or odours emit from the casing
Use only correctly sharpened drill bits which are suitable for the material being
drilled.
When drilling hard materials, firm pressure is required on the power tool
however, excessive pressure does not improve performance and places
unecessary pressure on the tool and its bit.
To minimize the chance of sudden stops and breaking through the material,
reduce the pressure on the drill and ease up on the bit .
Keep the motor running when pulling the bit back out of a drilled hole. This will
help prevent jamming.
5
v.081201