Terminals - Gewiss CHORUS GW 10 712 Mode D'emploi

INSTALLATION INSTRUCTIONS
The detector can be connected to 230V - 50 Hz mains supply(if requested) by means of a
230V ac - 12V dc power supply module(GW 10-12-14719)
1 2 3 4
L N
L (+)
12V ac/dc
L
N (-)
12V
N
1 NO/NC, 10A (NO) / 3A (NC) - 250V ac
Contact without potential that cuts off the flow of gas via a solenoid valve with manual
resetting (NO or NC).
Additional NO contact for local and/or remote signalling function.
1
2
Installation and wiring of electrical equipment and devices must be performed by qualified
personnel in compliance with the regulations and laws in force. The manufacturer will not
3
assume any responsibility for the use of products that should be installed according to
special room/installation standards; the responsibility for this lies with the installer. The
examples shown in this document are for illustration purpose only. When doing the wiring,
4
strictly follow the laws and regulations in force.
Warning: Before installing the product, turn off the power.
L N

Terminals

L
N
ac/dc
1 2 3 4
12V
ac/dc
1
2
3
4
22 22