Power Supply - Bontempi Music academy 16 5415 Manuel D'instructions

Masquer les pouces Voir aussi pour Music academy 16 5415:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 9
E N G L I S H
MAINS SUPPLY
The instrument can be supplied by the AC/DC (Vdc =9V
/ I = 500 mA)
(supplied) conforms to national and international safety
regulations covering electrical appliances. Insert the jack in
the DC 9V socket.
RECOMMENDATIONS: The socket (1) for the adapter plug must
be easily accessible. • Inserting the plug into the socket at the
back of the instrument automatically cuts off supply from the
batteries. • Ensure that the adapter is sufficiently ventilated •
Do not expose the adapter to drops or splashes of water. • The
AC/DC adaptor shall not be exposed to dripping or splashing
and that no objects filled with liquids, such as vases, shall be
placed on apparatus. • The AC/DC adaptor is used as discon-
nect device. • The AC/DC adaptor of apparatus should not be
obstructed OR should be easily accessed during intended used.
• To be completely disconnect the power input, the AC/DC
adaptor of apparatus shall be disconnected from the mains. •
Battery shall not be exposed to excessive heat such as sunshi-
ne, fire or the like. • minimum distances 15cm around the
apparatus for sufficient ventilations. • The ventilation should
not be impeded by covering the ventilation openings with
items such as newspaper, table-cloths, curtains etc. • No naked
flame sources such as lighted candles should be placed on the
apparatus. • Attention should be drawn to the environmental
aspects of battery disposal. • The apparatus should only be
used in moderate climates.
WARNING: All batteries or transformers with safety insulation
must be checked regularly for faults in cable, wire, or plug
insulation or other parts.
NOTE: Rating plate information was located at bottom
enclosure of the apparatus.
BATTERY SUPPLY
This instrument works with six 1.5V IEC R6 /AA batteries
(not supplied) which are inserted in the housing at the
bottom.
To open press on the part of the lid marked OPEN.
Fit the batteries as shown at the bottom of the housing.
R6/AA 1.5V
R6/AA 1.5V
R6/AA 1.5V
R6/AA 1.5V
R6/AA 1.5V
R6/AA 1.5V
R6/AA 1.5V
R6/AA 1.5V
R6/AA 1.5V
R6/AA 1.5V
R6/AA 1.5V
R6/AA 1.5V
2

POWER SUPPLY

positive central adapter
1
ADVICE ON USING THE BATTERIES
• Non-rechargeable batteries are NOT to be recharged.
• Rechargeable batteries must be removed from the
product before being charged.
• Rechargeable batteries are only to be charged under
adult supervision.
• Different types of batteries or new and old batteries
are not to be mixed.
• Use only batteries of the same or equivalent type.
• Batteries are to be inserted with correct polarity.
• Remove exhausted batteries to prevent leakage.
• Do not short circuit supply terminals.
• Remove batteries during long periods of non-use.
WASTE DISPOSAL STANDARDS
For information regarding the disposal of the items men-
tioned here below, please refer to Council Administration
office regarding specialised waste collection centres.
1 - DISPOSAL OF BATTERIES
Protect the environment by disposing
of batteries in the special containers
provided for this use.
2 - PACKAGING DISPOSAL
Take the paper, cardboard and corrugated board to the
appropriate waste collection centres. Plastic material must
be placed in the relevant collection containers.
The symbols indicating the various types of plastic are:
01
02
PET
PE
PVC
Key for the different types of plastic materials:
PET= Polyethylene terephtalate
PE= Polyethylene, code 02 for PE-HD, 04 for PE-LD
PVC =Polyvinyl chloride
PP= Polypropylene
PS= Polystyrene, Polystyrene foam
O= Other polymers (ABS, Laminates, etc.)
3. DISPOSING OF ELECTRICAL APPLIANCES
The wheelie bin symbol with a cross indicates
that the product must not be disposed of in
the domestic waste at the end of its useful
life. Instead, it should be taken to your nearest
designated collection point or recycling facility.
Alternatively, check with your retailer and return the pro-
duct when buying a replacement, on a one-to-one basis or
as free of charge in case the size is smaller than 25 cm.
Appropriate disposal promotes the recycling of parts and
materials, as well as helping to protect the environment
and human health. Under current legislation, strict penalties
are enforced against those disposing of products illegally.
For more information about the collection of special waste,
contact your Local Authority.
03
05
06
07
PP
PS
O

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

16 5415

Table des Matières