Omega Lift Equipment 30750 Instructions D'utilisation Et Manuel De Pièces page 5

ASSEMBLY
Model 31250:
1. Attach wheel bracket (#15) to side leg (#24) with bolt, washer & nut (#19, 12 & 11) up from bottom.
2. Insert bushing (#20) into wheel (#21).
3. Attach wheel (#21) to bracket (#15) with bolt, washer & nut (#16, 17 & 18).
4. Attach caster (#22) to side leg with bolt & washer (#23 & 17).
5. Attach center beam (#25) to side legs (#24) with two bolts & washers (#14 & 13) each.
6. Attach upright (#7) to center beam (#25) with two bolts (#8).
7. Place head plate assembly (#6) into collar of upright (#7). Insert bolt (#8) to fasten head plate assembly.
8. Attach all four mounting arms (#4) to head plate (#6) with bolt, flat washer, lock washer & nut (#5, 3, 2 & 1) each.
9. Insert handle (#10) into hole of head plate assembly (#6). Place handle grip (#9) on each end of handle.
Note: Check all fasteners for tightness, tighten where required.
Size of Hardware Kits
5 -Bolt M14x7
3 -Flat Washer M14
2 -Lock Washer M14
1 -Nut M14
8 -Bolt M12x14 3
11 -Nut M12
12 -Lock Washer M12
13 -Flat Washer M12
14 -Bolt M12x80 4
16 -Bolt M8x65
17 -Lock Washer M8
18 -Nut M8
19 -Bolt M12x20 2
23 -Bolt M8x16
Qty
4
4
4
4
2
2
4
2
10
2
8
Figure 5 - Assembly Illustration for Model 31250
5
)* B
!
!"#$%&'()
"#$%&'(