AEB BRIGHTICS Mode D'emploi page 13

All manuals and user guides at all-guides.com
MAGNETIC MOUNTING
The mounting surface should be metal and flat. Clean the mounting
surface with a 50/50 mix of isopropyl and water and dry thoroughly.
Place the TRAVELMATE-AMBER LED Beacon onto the mounting
surface. Note that the base should be in full contact with this surface.
The additional suction cups will make sure that the TRAVELMATE-
AMBER LED Beacon remains firmly in its position. Remove with gentle
care and do not slide.
OPERATION INSTRUCTION
• First touch lightly the on/off button, to wake up the TRAVELMATE-
AMBER LED Beacon.
• Press two seconds to switch on or off.
• Switch the flashing mode by tapping the on/off button.
CHARGING
• The voltage of the battery of this beacon is 11.8V, so if the battery
of vehicle is above 13V, then the battery of this beacon can be fully
charged while connected to the cigar plug. A battery below 13V
will only charge up to 80%.
• The charger type 100-240V, charges to 100%.
• The battery is fully charged when power button light goes from red
to green.
MAINTENANCE
You TRAVELMATE-AMBER LED Beacon has been designed for trouble
free operation and is maintenance free as far as you keep it clean
and do not drop it.