Enarco TIFON Serie Manuel D'instructions page 28

Power trowels with electric motor:
CLEAN THE MACHINE BY PRESSURIZED WATER
CHECK THE BLADE PITCH ADJUSTMENT
CHECK THE BLADE PITCH BOLTS AND CHECK OTHER BOLTS OF
THE MACHINE, IF NECESSARY TIGHTEN THEM
CHECK THE V-BELT TIGHTNESS
CHECK THE BLADES
PUT OIL TO THE GREASE FITTINGS
GEARBOX
Check the gearbox oil level before every operation; change the gearbox oil every year. On the side
of the gearbox there is a plug. Use "SHELL TİVELA COMPOUNDS A (400gr)" gear oil or equivalent.
MACHINE CLEANING
Clean the machine after it has been used to prevent the collection of hardened cement. Hard
concrete/cement paste is very difficult to remove. To clean it, use an old brush or hand brush.
en
CHANGE OF BLADES
Be careful when replacing old blades. Due to the way the blades wear, the old blades become very
sharp, like a knife blade. As a safety precaution, use very heavy duty gloves during this operation to
prevent the hands being cut. Remove bolts and lock washers on each trowel arm and remove the
blades. Before installing new blades clean all concrete/cement from bottom and side of the trowel,
be sure trowelling edge of the blade is behind the trowel arm. Install bolts and lock washers on each
trowel arm and fasten securely.
TIGHTEN THE V BELTS
If you notice a loose on V belt, check the tightness.Especially in first using and V belt change.Check
the V belt tightness after 8 hours later.Using your head finger push the V belt from its middle point.It
must strech about 2cm.If it strechs more, it is loose.
For tightening; loose the motor fixing screws.(tiil motor moves away on the table) Loose the motor
lock nut.Loose the screws, push the motor backward. Checking the V belt tighteness, do the same
operations.Until tighteness of V belt is desired value, screw the motor luck nut, and then screw the
motor fixing screws.
10
DAILY WEEKLY
X
X
X
TROWELS WITH ELECTRIC OR PETROL ENGINE
X
X
X
X