Wilfa Power Fuel XL PB1S-P2000 Instructions page 8

• Switch off the appliance and disconnect from the
EN
power supply before changing accessories or
working near parts that move in use.
• If the motor has overheated, the temperature
monitoring system will trigger and the motor will
stop. Switch off and unplug the appliance and
let the motor cool down. The motor temperature
monitoring system will reset after the blender
has been unplugged from the wall socket for 45
minutes. After this time, the blender can be used
again.
• Care shall be taken when handling the sharp
cutting blades, emptying the bowl and during
cleaning.
• Do not attempt to disassemble the blade assembly
or touch any rotating parts.
• Any servicing should be performed by an
authorized service representative. Do not attempt
to disassemble, repair, or modify the appliance.
• Always disconnect the appliance from the power
supply if it is to be left unattended and before
assembling, disassembling or cleaning.
• Be careful if hot liquid is poured into the blender
as it can be ejected out of the appliance due to a
sudden steaming.
INSTRUCTION MANUAL · POWER BLENDER
6