Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
RECEIVERS
1.- EQ: equalization auto setting. Adjusts the signal to the length of Cat 6 cable being used. It is possible
to adjust the signal to the length of Cat 6 cable being used manually. To do so, press the EQ button 3
times (the first two presses correspond to automatic setting). There are 10 equalization levels, with each
press advancing 1 level until it returns to automatic equalization.
2.- CAT. 6: input to connect to the splitter output, RJ-45 connector. Use a length of Cat 6 cable that does
not exceed 40 metres.
3.- SIGNAL: LED connection indicator. It remains lit when the signal transmission is stable. The light flashes
when the signal is not stable.
4.- 5 V DC: power supply input.
5.- OUTPUT: signal output, HDMI connector.
6.- IR IN: remote control receiver connection input.
CONNECTION AND OPERATING
-
Connect the signal source to the splitter INPUT using HDMI cable.
-
Then, connect the receivers required to the splitter OUTPUT using Cat 6 cable with a length of Cat 6
cable that does not exceed 40 metres.
-
Connect the receivers' output to the TV moniors mediante cable HDMI.
-
Connect the transmitter to the power supply using the mains adapter provided.
HDMI
DVD/BLU-RAY
NOTE: it is recommended that good quality Cat 6 cables with FTP/SFTP shielding are used. The cables
must have shielded connectors with the cable shielding connected to the connector shielding. This
improves the reliablity of the HDMI extenders, avoiding ground loops produced by interconnecting
devices (player/receiver and TV) with different ground reference which could cause losses or
image cutting.
EQ
SIGNAL
CAT. 6
1
2
3
FO-15CAT4E (Tx)
CAT 6
FO-15CAT4E
(Rx)
HDMI
HDMI
- 3 -
5 V DC
OUTPUT
IR IN
3 A
4
5
6
CAT 6
CAT 6
FO-15CAT4E
FO-15CAT4E
(Rx)
(Rx)
HDMI
HDMI
EN
CAT 6
FO-15CAT4E
(Rx)
HDMI
Publicité
Table des Matières
