Filex 2062000003 Notice De Montage page 5

English
Assembly instructions
The figures between the brackets refer to the corresponding part number.
1. Mount the perforated panels
a. Attach the fixing triangles to the perforated panel (6) using M5 screws and wing nuts.
b. Attach the lighting set (7) to the two perforated panels (5, 6) (figure 7) using screws and
wing nuts M5.
c. Drill four holes with a diameter of 4 mm in the countertop at the locations where the
fixing triangles are to be fixed to the countertop (two holes per fixing). Finally fix the
panel with the screws (figure 6).
2. Attach the back panel (4) to the base cabinet (1) using two M5 screws (figure 1).
3. Attach the drawer cabinet (2) to the other side of the countertop (3) using two M5 screws, nuts
and washers (figure 2).
4. Attach this construction to the shelf (4) using four M5 screws, nuts and washers (figure 3, 4).
5. Installing the countertop
a. Remove the steel panel from the countertop.
b. Remove the drawer from its guides. This can be done by pulling the drawer completely
out and then pressing the locking tabs on the left guide upwards and on the right guide
downwards (see figure 5).
c. Put the wooden countertop on the construction and align the fixing holes to the correct
position.
d. Fix the wooden countertop to the structure using six screws, nuts and washers M8
(figure 4).
e. Slide the steel panel over the wooden countertop from the front (figure 4).
f. Fix the steel panel with M4,2x19 self-tapping screws to the sides.
All manuals and user guides at all-guides.com