Haussmann Xpert HT05 Manuel De L'utilisateur page 21

All manuals and user guides at all-guides.com
OPERATING INSTRUCTIONS
The handle is designed with a safety button to prevent accidental starting.
To start the trimmer:
Press and hold the safety button located on either side of the handle, then press the
trigger.
Continue holding the trigger and release the safety button. The trimmer will be on for
as long as the trigger is pressed.
Safety button Trigger
Release the trigger to stop the trimmer.
PLEASE NOTE - When the battery is running low a cut out mechanism will stop the
product from working.
This is to protect the Li-Ion battery from running completely flat, and will maintain the
battery life.
If this happens during normal operation, refer to the section on battery
charging.
Cutting with your trimmer
Hold the trimmer away from the body using both hands. Stand in a secure and
stable position.
The double edge blade enables cutting with either a side to side or up and down
action.
Before cutting, check the hedge for any objects such as wire fences that could
damage or jam the trimmer blade.
When cutting move slowly and steadily along the line of cut so that stems are fed
directly into the blades.
Cut the sides of the hedge first then the top. To keep the sides of the hedge flat
cutting upwards with the growth is recommended. To achieve a level finish, fasten a
piece of string along the length of the hedge and use a guide to give an even cut.
Take care not to cut objects such as wire that may be hidden in the hedge as this
could cause damage to the cutting blades and drive mechanism.
Take care not to overload the trimmer. Attempting to force the trimmer to cut may
damage the motor. To prevent overloading check to see if the hedge is very thick or
dense and to reduce load on the motor cut long or thick hedges in stages with
several light cuts.
NOTE: the trimmer is fitted with a self-resetting protective cut-out. This will
stop the trimmer if the motor becomes overloaded.
If this occurs, wait a few seconds for the cut-out to reset and then use lighter
cuts.
21