Timer Function (*Optional) - Porter&Charles CI76V Instructions D'utilisation Et D'installation

Timer function (*optional):

The timer function is realized in two versions:
Minute minder timer (1..99 min):
The minute minder timer can be operated if the cooking zones are switched off. The timer display
shows "00" with a blinking dot.
Use the Timer Sliding Buttons
between 0 and 99 minutes. If there is no operation in 10 seconds, the minute minder timer will be
set and the blinking dot will disappear. After the timer is set, the time runs down according to the
adjustment.
When the time is over, a signal sounds and the timer display blinks. The sound signal will be
stopped automatically after 30 second and/or by operating any key.
The minute minder timer can be changed or switched off any time by using the Timer Sliding
Buttons
the minute minder timer.
Cooking zone timer (1..99 min):
When the hob is switched on, an independent timer can be programmed for every cooking zone.
Select a cooking zone, then select the temperature setting and finally activate the timer setting
key , the timer can be programmed as a switch off function for a cooking zone. Around the timer
four LEDs are arranged. These indicate for which cooking zone the timer has been activated.
10 seconds after the last operation, the timer display changes to the timer that will run out next (in
case of programming more than 1 cooking zone).
to increase/decrease the time. Adjustment range is
. Switching off the hob by touching
9
at any time will also switch off