Channel Delay; Equalizer; Sound Mode - Coby DVD968 Manuel D'instructions

System Setup
LPCM Out
When the DIGITAL OUTPUT option is set to SPDIF/PCM, this item is avail-
able.
Select a sample rating for the analog audio output. There are two op-
tions, 48KHz and 96KHz.
Use the standard 48 KHz option unless your amplifier/receiver
can support a sample rate of 96 KHz over a coaxial digital con-
nection.

Channel Delay

Set the delay time for the center, rear speakers and the subwoofer.
You may need to set a delay to compensate for the difference in audio
propagation times caused by the distance of the speakers to the listener.
Use the navigation keys <UP> or <DOWN> to select a speaker,
then use the navigation keys <LEFT> or <RIGHT> to adjust the
distance differential.
This unit does not support delays for when the distance between
the center or surround speakers and the listener are greater than
that between the front speakers and the listener.
In case the channel delay settings cannot match your speaker
configuration, please set all distances to 0cm. If possible, use
your receiver/amplifier to set the channel delay.

Equalizer

Sound Mode

Select a sound mode in this item.
www.cobyusa.com Page 39