Table des Matières
Publicité
To assemble your Channel Loader:
1. Remove all components from the box.
2. Choose the angle that fits your
situation/vehicle and Mount Suction Cups to
the Frame.
3. Insert Phillips Head Bolts with washer into
Cups and through Frame.
4. Install Lock nuts and washers to the Bolts
with Wrench.
NOTE: DO NOT OVER TIGHTEN LOCK NUTS.
AFTER INSTALLATION, THE SUCTION CUPS SHOULD
PIVOT UP AND DOWN FOR CONTOURED SURFACES.
NOTE: SURFACE AREA AND SUCTION CUPS MUST BE CLEAN AND FREE OF DUST.
PLACE CHANNEL LOADER ON WINDOWS AND FIRM SURFACES ONLY.
INSTALL CHANNEL LOADER ON A HATCHBACK OR SUV:
1. Confirm the mounting
surface area and suction cups
are clean and free of dust.
2. Secure the Channel Loader
to the rear of the vehicle as
shown.
3. Ensure the suction cup(s)
are well attached before
loading.
MALONE
ASSEMBLY & INSTALLATION
AVOID PLASTIC SPOILERS AND WINGS.
3 Adjustable angles to
accommodate all
vehicle types
INSTALL CHANNEL LOADER ON A SEDAN:*
1. Confirm the mounting
surface area and suction cups
are clean and free of dust.
2. Secure the Channel Loader
to the trunk of the vehicle as
shown.
3. Secure the second Channel
Loader to the rear window as
shown.
4. Ensure the suction cup(s) are well attached
before loading.
*May require use of second Channel Loader.
R
Publicité
Table des Matières
