Attachment To Pipes; Attachment Methods - Bartec TWISTO/N-B Serie Consignes D'installation

TWISTO/N-B Installation Instructions

Attachment to pipes

Attachment methods

NOTICE
It is recommended to install the TWISTO/N-B connection kit on a mounting bracket ("off-pipe") to protect it from excessive temperatures (as shown
on the left). However, when used in moderate temperature conditions all TWISTO/N-B connection kits can also be directly attached to the pipe (as
shown on the right).
Off-pipe installation:
 Attach the mounting bracket (see section Accessories on page 10)
to the pipe using cable ties.
 Attach the TWISTO/N-B connection kit to the mounting bracket and
the trace heater to the pipe using polyester tape or cable ties.
 Make sure that the distance between 2 attachment points does not
exceed 12" (300 mm) on plastic pipes or 36" (900 mm) on steel
pipes.
21-56N0-7N0001/392164
All manuals and user guides at all-guides.com
1A
Reservation Technical data subject to change without notice.
No claims for damages arising from alternations, errors or misprints shall be allowed.
On-pipe installation:
 Attach the trace heater and the TWISTO/N-B connection kit to the pipe
using polyester tape or cable ties.
 Make sure that the distance between 2 attachment points does not
exceed 12" (300 mm) on plastic pipes or 36" (900 mm) on steel pipes.
1B
Page 8 / 20