Power Specifications - Blendtec COMMERCIAL Serie Guide De L'utilisateur

3.2 BLENDER JAR ASSEMBLY
The blender jar assembly consists of the blender jar, blade assembly, and lid�
These components are integrated to ensure consistently blended drinks and
greater operator safety�
• Lid: The lid seals liquids within the jar during blending� Some models have a
vent that provides pressure relief when blending hot foods�
• Jar: Your jar is durable, BPA-free, and easy to clean�
• Blade Assembly: The uniquely designed stainless steel blade provides fast,
consistent blending�
NOTE: Never operate the blender with more than the marked capacity of the jar.

3.3 POWER SPECIFICATIONS

Your Commercial series blender is certified for use with a specific circuit voltage,
depending on model� Make sure to check your model's power specifications and use a
protected circuit when operating your unit�
SECTION 4:
INSTALLATION & OPERATIONAL OVERVIEW
4.1 STEALTH 895 NBS™
4.1.1 Installation
Stealth Above Counter Installation
• Select a location that is near an electrical outlet� Also consider proximity to
ingredients, and patrons as well as available counter space�
• Place the blender on the counter in a spot where the air intake vents on the
sides and exhaust on the back of the blender are unobstructed�
• Ensure there is enough room above and around the unit to allow for unhampered
movement of the sound enclosure (see Figure 1 for measurements)�
• Plug the unit into an outlet with appropriate electrical protection�
Stealth In-Counter - Preparation for Installation
Note: You may locate your Blendtec Stealth in the same space as your previous
Blendtec in-counter blender. Just remember to ensure proper spacing for the
sound enclosure (see Figure 1 for measurements).
• Identify the desired blender location� Consider proximity to ingredients, and
patrons as well as available counter space� Also ensure that an electrical outlet
is readily accessible�
• Ensure the location meets all dimensional requirements (see Figures 1 and 3)�
• The countertop can be no thicker than ¾" (1�9 cm)� A thicker countertop will obstruct
motor ventilation�
4