Parts List - ITC POWER TOOLS SPT324 Manuel De L'utilisateur

No. Description
1 Screw
2 Chuck key
3 Chuck
4 Circlip
 Outer plate
6 Washer
7 Shaft
8 Split pin
9 6003 Bearing
10 Head shell
11 Gear
12 081210 Roller pin
13 071109 Roller pin
14 Gear shaft
15 Split pin
16 No.2 Gear
17 071109 Roller pin
18 Cover
19 6000 bearing
20 Bearing cover
21 Screw
22 Rotor

PARTS LIST

Please refer to the schematic drawing on page 15.
WARRANTY
ITC branded power tools, air nailers staplers and compressors are designed for
use in DIY (do-it-yourself), light or intermittent duty, semi-professional applications.
They are not intended for use in professional, production, industrial or continual use
applications.
ITC makes every effort to ensure that its products meet high quality and durability
standards and are warranted for two years against manufacturers' faults and
defects for a period of two years from the date of purchase to the original owner.
ITC will REPAIR OR REPLACE (at our discretion) merchandise deemed by the
company to be defective, provided that it is has not been misused, abused, altered,
or repaired by anyone other than an authorized repair centre.
Please consult the ITC catalogue or your nearest ITC distributor to determine those
products that are covered by our over-the counter warranty. Any ITC tool that fails
during normal use and within the specified warranty period and qualifies for over-the
counter warranty must be returned to its point of purchase for replacement or credit.
Any item not listed as over-the-counter warranty must be shipped, prepaid freight,
to an authorized repair depot accompanied by a copy of the invoice specifying the
date that the item was purchased. Returned tools that are not accompanied by a
proof of purchase (Copy of Invoice) will not be repaired or replaced under warranty.
This warranty does not extend to normal wear or consumable parts such as brad
and staple gun driver blades, grinding discs, saw blades, driver bits, electric motor
brushes, worn chords, etc. It also does not apply to ITC tools used in professional,
production, industrial or continual use applications.
For a listing of the authorized repair centers please refer to the ITC catalogue.
No. Description
23 608 Bearing
24 Bushing
25 Housing
2 Screw
2 Stator
28 Handle
29 Body shell
30 Brush holder
31 Carbon brush
32 Brush cover
33 Back cover
34 Handle
35 Screw
36 Screw
37 Handle cover
38 Screw
39 Cable clip
40 Cable Protector
41 Plug
42 Switch
43 Screw
44 Screw