Functional Description; Operating Procedures - Altocraft AG370 Manuel De L'utilisateur

SPECIFICATIONS
Your new ALTOCRAFT AG370 includes the following:
Voltage : 120 volts AC, 60 Hz

 Current rating : 5..2 amp

No-load speed : 11,500 RPM
Accessories:
 4-1/2" (115mm) grinding wheel
Side handle

Hex wrench


FUNCTIONAL DESCRIPTION

Figure 1 names the major components of the AG370 grinder:
A
ON - OFF switch
B
Spindle lock
C
Grinding wheel
D
Inner flange
E
Wheel guard
F Side handle

OPERATING PROCEDURES

Grinding Wheel
Your AG370 grinder is designed to accept only 4-1/2" abrasive discs with a 7/8"
bore. Check to ensure that any discs you use on this machine are rated for the
11,500 RPM speed of your grinder. Check also for any damage to an abrasive disc
before you install it. Any disc that shows a crack, has been dropped, or subjected
to other damage due to temperature extremes or solvents should be discarded.
damaged disc can fly apart in use and may cause serious injury to the operator or
bystanders.
Guard
Your grinder comes with an adjustable wheel guard installed. This is to allow you to
grind at various angles and still be protected to some extent from flying residue or
debris should a disc shatter in use. Unplug the grinder. Loosen the clamping screw
on the collar and rotate the guard to give you protection and expose the disc on the
appropriate side. Tighten the screw to clamp the guard in place. Do not use this
tool with the guard removed.
Side Handle
The auxiliary side handle for your grinder may be mounted on either the left or right
side of the tool. Unplug the grinder. Screw the handle firmly into the threaded hole
on either side of the metal grinding head.
12
AG370
All manuals and user guides at all-guides.com
A
B
C
F
D
E
Fig. 1