Freeman PE2118G Mode D'emploi page 7

TROUBLESHOOTING
WARNING:
Stop using tool immediately if any of the following problems occur. Serious personal
injury could result. Any repairs or replacements must be done by a qualified service
person or an authorized service center.
PROBLEM POSSIBLE CAUSE(S)
The internal electronics of the tool
have not reset.
The battery is low or not charged.
The battery is damaged.
Tool doesn't turn on
The work contact element is locked
(LED lights do not
turn on). into position.
The battery terminals are dirty.
Damaged internal electronics.
Work contact element is not
Tool doesn't actuate
depressed.
(LED lights do turn
Work contact element is jammed.
on).
Damaged electronics.
Tool does not
The battery charge is low.
actuate (LED light
The battery is to hot.
is red).
A fastener is jammed in the tool.
No nails in the magazine.
Incorrect fastener has been loaded.
Tool operates, but
Debris in nose piece.
no fastener is
Debris in magazine.
driven.
Worn magazine or drive blade.
The battery has a low charge or is
damaged.
Tool operates, but
The depth adjust is set too shallow.
does not drive the
Tool is not press firmly against the
fastener fully.
workpiece.
Material and fastener length is too
rigorous on the tool.
12
HTTP://WWW.FREEMANTOOLS.COM
MODEL: PE2118G
CORRECTIVE ACTIONS
Remove the battery from the tool, wait 3
seconds and reinsert.
Charge the battery.
Replace the battery.
Unlock the work contact element.
Clean the battery terminals.
See authorized service center.
If the tool is set in the single fire setting,
release the trigger or work contact element
Then try refiring the tool.
Unlock the work contact element.
See authorized service center.
Charge or replace battery.
Let the tool cool down.
Remove the battery from the tool and clear
the jam from the gun. Then push the drive
blade back and reinsert the battery.
Load more fasteners in the magazine.
Insert the fasteners recommended by the
manufacturer.
Clean the nose piece with pneumatic air
tool oil and a clean cloth.
Clean the magazine with pneumatic air tool
oil and a clean cloth.
See authorized service center.
Charge or replace the battery.
Rotate the depth adjust towards the deeper
setting.
Press down more firmly on the workpiece.
Choose a more appropriate material and
fastener for your application.
1-888-669-5672
MODEL: PE2118G
PROBLEM POSSIBLE CAUSE(S)
The incorrect fastener is loaded in
the tool
Low battery charge or damaged
battery
Jammed fastener
Debris is in nose piece
Debris is in magazine
Worn magazine
Worn or damaged pusher spring
WARNING:
Only use Freeman Authorized Repair Parts. For questions please call 1-888-669-5672 or
visit our website at http://www.freemantools.com
WEARABLE PARTS
Repair parts can be ordered from our website: http://www.freemantools.com
HTTP://WWW.FREEMANTOOLS.COM
CORRECTIVE ACTIONS
Load fasteners recommended by the
manufacturer
Charge or replace battery
Clean the nose piece with pneumatic air
tool oil and a clean cloth
Clean the magazine with pneumatic air tool
oil and a clean cloth
See authorized service center
See authorized service center
13
1-888-669-5672