Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Volume 1
5
0
10
Input 1
Mic/ Inst.
any other type may cause leakage, explosion, and/or personal injury. Not user serviceable, refer to qualified service technician.
MADE IN CHINA
FABRIQUÉ EN CHINE
MANUFACTURED FOR YORKVILLE SOUND, CANADA
Traynor TVM10 Battery Powered Combo-Amplifier
General
The Traynor TVM10 is a 10-Watt battery powered combo-amplifier that answers the need for a portable, all-purpose
sound system. The TVM10 can be used practically anywhere. The amp features RCA auxiliary input jacks, which
may be used to connect sound sources such as CD players, tape decks, MP3 players or even laptops (using the
appropriate audio adapters).
Control Panel
Input 1
This versatile input has been optimized to accept
either low or high-impedance microphones, although
any line level signal may also be used. The combi-
connector accepts cables with either an XLR or ¼-
inch TRS phone plugs.
Volume 1
The Channel 1 volume control adjusts the level of the
audio signal connected to the Input 1 jack.
Input 2
An instrument (guitar, bass or keyboard) or a high
impedance microphone may be connected to the
TVM10 using this ¼-inch phone jack using a standard
¼-inch shielded cable.
Volume 2
The Channel 2 volume control adjusts the level of the
signal connected to the Input 2 ¼-inch jack.
All manuals and user guides at all-guides.com
Volume 2
Bass
5
0
0
10
10
Input 2
Instrument
CAUTION: This unit contains a sealed rechargeable battery. Improper disposal of battery or replacement with
TVM10
DO NOT USE UNIT
WHILE CHARGING!
Low Mid
Hi Mid
0
0
10
10
10
10
10
E q u a l i z a t i o n
The Power LED illuminates Yellow when the unit is on and fully charged. Red illumination indicates low
battery power status. To recharge, turn Power off and connect supplied 15 VDC charger to charger jack.
The Charger LED illuminates Red while unit is charging. When charging cycle is
complete, the LED will automatically turn off. When the charger is plugged in and the
Power LED fails to illuminate, the unit must be recharged for 24-hours. If the Power
LED fails to illuminate Yellow after charging, the internal battery may be deemed dead.
Refer to Owner's Manual for more detailed instructions about replacing the internal battery.
Charger LED
DC Charger
Illuminated
When Charging
-
15 VDC
+
1500 mA
Equalization - General
The TVM10's 4-band EQ adjusts the Bass, Low Mid,
Hi Mid and Treble for inputs 1 and 2.
Note: The tone controls do not affect the RCA Aux
(Media) Inputs.
It is suggested that all four controls be set to the
center, or 0, position (nominal) prior to operation,
adjustments may be made to achieve the desired tone.
If feedback occurs while you are using a microphone,
turn down the Treble and/or High Mid until it stops.
Aux. Inputs
The Aux. Input (Media) RCA jacks can be used to
connect a tape deck, CD player, MP3 player, drum
machine, computer or any line-level audio source.
Since the TVM10 is a mono amplifier, these jacks
sum the signals internally (mixing the incoming L and
R stereo signals into a mono signal). Using a stereo
signal? Connect to both RCA jacks as usual, so that
both channels (L and R) are amplified. If the signal is
mono, (e.g. the monitor or aux. output from a mixer),
connect to either the L or R jack.
TVM10
Treble
0
10
10
Aux. Input
Phones
(Media)
MODEL TYPE: YS1046
1v2
Power
Publicité
Table des Matières
