Installation Requirements; Electrical Requirements; Location Requirements; Air Purifier Use - Whirlpool WP1000 Guide D'utilisation Et D'entretien

INSTALLATION REQUIREMENTS

Electrical Connection
To properly install your air purifier, you must determine the type of electrical connection you will be using and follow the instructions
provided for it here.
The air purifier should be connected to a 115 V, 60 Hz, 15- or 20-amp fused 3 prong grounded outlet.
The use of a time-delay fuse or time-delay circuit breaker is recommended.
You will need a level surface at least 6" (15.2 cm) from heat
sources such as ranges or heaters.
Do not block air openings or place air cleaner on a soft
surface such as a bed or sofa.
Operate indoors only.
NOTE: Before operating the air purifier, record the date of installation on the HEPA filter. Under normal conditions, the HEPA filter should
be replaced annually, and the pre-filter should be replaced every 3 months. To remove and replace either filter, see "Filter Replacement"
in the "Air Purifier Care" section.
4

Electrical Requirements

Location Requirements

AIR PURIFIER USE

A
A. 6" (15.2 cm) minimum clearance