Napoleon IM-UGC18-CN Mode D'emploi page 4

4
TOOLS REQUIRED FOR ASSEMBLY (tools not included)
EN
3/8" (10mm)
GAS AND ELECTRICAL PIPING
The piping up to the gas grill is the responsibility of the installer and piping should be located as shown
in the built-in instructions. Do not use hose to connect the unit. It must be connected with either rigid
pipe, copper tube or an approved flexible metal connector. The installation must comply with CAN B149.1
Natural Gas and Propane installation code in Canada, or to the National Fuel Gas code, ANSI Z223.1 in the
United States. The minimum recommended piping size is NPS 1/2" for rigid pipe, and 1/2" OD for copper
tubing (based on a 20 ft run). Longer runs may require larger sizes to conform with CAN B149.1. Propane
Gas Installation Code in Canada or to the National Fuel Gas Code, ANSI Z223.1 in the United States.
Look to the manual that came with the gas grill for further instructions.
To ease installation and piping, removable knockouts have been provided in the side panels and in the
center of each backpanel. The knockouts in the side panels should be removed before the cabinets are
bolted in a row. Only remove the knockouts that are required for the piping of any gas, plumbing or
electrical lines.
KNOCKOUTS
www.napoleon.com N415-0416 DEC 08.21