Publicité
Les langues disponibles
Les langues disponibles
STEP 3
To sync two bases with the Sync Cord, see installation
instructions in Owner's Manual
Locate the battery backup strap
Store the battery backup strap in a
convenient location for emergency use.
For operating instructions, see owner's
manual.
STEP 4
Uncoil input cord (connected to
control box's power port) and plug it
into Power Supply.
STEP 5
Uncoil Power Cord and connect to
Power Supply. Place Power Supply on
ground and extend from base. Ensure
that Power Supply and all attached
cords are directed toward the desired
surge protector.
STEP 6
Carefully flip the base over onto its legs.
Important: Two people are required to move the bed base.
Do not drag frame across the floor or rest frame on its side, as
excessive pressure may damage the legs.
Head Massage On/Off
Lift and lower Head
Preset Position #1
Anti-Snore Preset Position
REMOTE GUIDE
Increase Lumbar
Support
section of base.
STEP 7
Plug the base and into a power source. A surge protector is
strongly recommended.
STEP 8
Install (3) AAA batteries in remote control.
Quickly test functions before placing mattress
on base to verify proper setup.
Press FLAT to return base to a flat position.
STEP 9
Slide left side of the mattress retainer bar into bracket. Pull retainer
bar to opposite bracket and secure right side.
Setup is now complete! Test all functions on remote to ensure
proper setup. For more information please see Owner's Manual
For customer support, visit www.ergomotion.com
or call: 1-888-550-3746
Massage Timer
Foot Massage On/Off
Underbed Lighting
Decrease Lumbar Support
Lift and lower Foot
section of base.
FLAT preset position.
Preset Position #2
ZERO-G
®
legs to a higher level than your heart
helping to relieve pressure off lower
back and promote circulation.
preset postition adjusts your
Publicité
