Vigor Equipment 1922 Mode D'emploi page 25

All manuals and user guides at all-guides.com
3 Design and Function
8. When the test is completed, the display shows
the actual volts and the actual CCA or %. The
battery cell tester's tolerances are +/- 0.05 V
for voltage measurement and +/- 5% CCA for
starting current measurement.
to select: SOH (STATE OF HEALTH)
CHARGE)}.
One of six results will be displayed:
GOOD / PASS
xx.xx V xxxx SAE
GOOD / RECHARGE
xx.xx V xxxx SAE
RECHARGE / RETEST
xx.xx V xxxx SAE
BAD / REPLACE
xx.xx V xxxx SAE
BAD CELL / REPLACE
xx.xx V xxxx SAE
LOAD ERROR
are not connected properly. Please fully charge
the battery and retest after excluding both previous
reasons. If reading is the same, the battery should be
replaced immediately.
{Press the e / - key
or SOC (STATE OF
GOOD / PASS :
The battery is good & capable of
holding a charge.
GOOD / RECHARGE :
The battery is good but needs to
be recharged.
RECHARGE / RETEST :
Battery is discharged, the battery
condition cannot be determined
until it is fully charged. Recharge
and retest the battery.
BAD / REPLACE :
The battery will not hold a charge.
It should be replaced immediately.
BAD CELL / REPLACE :
The battery has at least one cell
short circuit. It should be replaced
immediately.
LOAD ERROR :
The tested battery is bigger than
2000 CCA or 200 AH. Or the clamps
25