Barrette SELECT Serie Mode D'emploi page 6

ANGLED RAIL INSTALLATION:
1.
After posts have been installed, determine angle
of railing (Fig. 1).
2.
Pre-drill
bracket only. Then, fasten bracket to base at the
determined angle with one #10 x 1" screw (Fig. 2).
NOTE:
"Top" brackets have screw holes on the sides.
3.
Cut railing to desired length. Place bracket on
each end of top and bottom rails (Fig. 3). Fasten
bottom bracket to base with one #10 x 1" screw.
4.
a. Position the rail section between the posts (Fig. 4).
b. Mark four screw hole locations on each
bracket. Set rail section aside, then pre-drill
diameter holes in post at each mark (Fig. 5).
6
⁄ " diameter holes in base of top
1
8
Top View
Determine
Angle
Top View
⁄ "
1
8
Mark Holes
Mark Holes
Fig. 1
Fig. 2
Base
#10 x 1" Screw
Fig. 3
Top Rail
Bottom
Rail
Fig. 4
Fig. 5