Operation; Leak Check; Lighting Top Burners - Furrion FGH3Z45-BL Consignes D'utilisation

Operation

Leak Check

Always perform a leak test for possible
leaks according to the manufacturer's
instructions before any operation.
Pressure/Leak test using 11-13.8 WC
pressure.
WARNING
● Extinguish all open flames.
● NEVER leak test when smoking.
● Do not use the appliance until
connection has been leak tested
and does not leak.
1. Make sure all control knobs are
turned to OFF position.
2. Apply a gas leak detection liquid to
the connections.
3. Any gas leaks will be indicated by
bubbles.
4. To stop the leak, tighten the loose
joint, or replace the faulty part with a
replacement part recommended by
retailer.

Lighting Top Burners

WARNING
Top cover must be open when main
burner is in operation.
Match Lighting:
1. Before lighting, check to make sure
the control knobs are turned to OFF
position.
2. Check that the main gas tank valve is
open.
9
3. Turn the appropriate burner knob
counterclockwise to
(Fig. 9)
NOTE: Do not attempt to light more
than one burner at a time.
Fig. 9
4. IMMEDIATELY strike and place a
burning long wooden match (or the
match extension or a butane lighter
with extension) through the spaces in
the grate near the ports of the burner
to light the burner. (Fig. 10)
Fig. 10
5. Repeat steps 3 and 4 to light the
other burner(s) as needed.
6. Push and turn the burner control
knob to adjust the flame to desired
level. (Fig. 11)
position.