Before Initial Use; Charging The Battery - essentiel b EBDES1 PULSE LUXE Notice D'utilisation

before initial use

• Charge your electric toothbrush before using it for the first time. Leave the
toothbrush on its charging bracket for an initial charging time of approximately
1 hour 15 minutes. The charge indicator (8) flashes green for the entire charging
period. (Please refer to the "charging the battery" section for further information).
• Clean the new brush head by running it under tap water.

charging the battery

• Make sure the charging base is placed on a flat, stable and dry surface.
• Place the body of the appliance on the charging base.
• Unwind the power cord completely and plug it into a power outlet. The charge
indicator (8) flashes green to indicate that the toothbrush is charging.
• Once initial charging is complete (see above), the charging time is approximately
1 hour 15 minutes for a battery life of approximately 60 minutes.
• When charging is complete, the charge indicator (8)
• If the battery is low or the toothbrush stops working, the charge indicator (8)
starts flashing yellow. This means you must charge the battery. You have
approximately 10 minutes of operation left.
• If the battery is almost flat, the charge indicator (8)
before the appliance switches off.
You can put the toothbrush back on the charging base after every use so that it is
always charged for the next use.
24
V.1.0
before initial use
use
1.
2.
3.
4.
5.
Your toothbrush has four modes of operation:
6.
switches to solid green.
7.
flashes red for one minute
8.
Smart reminder
Every 30 seconds, the toothbrush briefly stops to invite you to change the brushing
area (4 areas: top front/back and bottom front/back).
After two minutes, the toothbrush briefly stops three times to indicate that you have
reached the recommended brushing time. Do not hesitate to consult your dentist for
brushing advice.
Install the brush head on the body of the appliance.
Moisten the brush head by running it under tap water.
Apply a small amount of toothpaste to the brush head.
To avoid splashing, do not switch on the toothbrush before placing it in your
mouth.
Place the toothbrush in your mouth and press the on/off button. The toothbrush
switches on in "Normal" mode. The indicator light of the "Normal" mode lights up.
• "Normal" mode (3): standard mode for daily tooth cleaning.
• "White" mode (4): teeth whitening and stain removal mode.
• "Soft" mode (5): suitable mode for sensitive teeth and gums.
• "Pulse" mode (6): normal mode with slight pulsing added for more intensive
brushing.
To switch from one mode to another, press the on/off button once or several times
in succession (within a 4-second interval).
To switch off the toothbrush when you have finished, press the on/off button.
Remove the toothbrush from your mouth and then clean the brush head and
toothbrush under tap water.
25
V.1.0
use