V-TAC SMART LIGHT Serie Mode D'emploi page 5

Step9: To pair the device with lamp make sure the light is blinks rapidly.
Once the light blinks rapidly, the lamp is in pairing mode. If the bulb is not blinking rapidly, you
can do one of the following steps:
A. Switch the bulb on & off repeatedly for 3 �mes, with short intervals of less than 2 seconds.
B. Tap the 'How to make light blink rapidly' link. (ref image below)
Network Modes:
1) EZ Mode: Light flashes twice per second
2) AP mode: Slow flash, once every 2 second
Confirm if the light blinks rapidly, select the WiFi network, and enter the password.
Step8: Choose 'Ligh�ng' to start pairing the
lamp to the app.
4
ENGLISH