Table des Matières
Publicité
Getting Started
Before connecting your ScreenPlay Director TV Tuner, decide how you want to get your media content. In addition
to receiving over-the-air television programs, ScreenPlay Director enables you to play media files from your home
network, from a connected USB device, or from the ScreenPlay Director's hard disk.
• If you plan to get media content from your home network or a connected USB device, proceed to the
instructions on connecting and setting up the ScreenPlay Director.
• If you plan to load a lot of media content to the ScreenPlay Director's hard disk, it will be fastest to connect
first to your computer to transfer files and organize your multimedia library. See the user's manual for
detailed instructions.
Connecting and Setting Up ScreenPlay Director
It will be easiest to set up your ScreenPlay Director if it's connected to both your TV and your network before you
power it up the first time. It doesn't matter if you connect to your network first or your TV first.
NOTE: In order to receive over-the-air broadcast television signals, the ScreenPlay Director must be connected to
a TV antenna via the coaxial connector.
Connecting the ScreenPlay Director to Your TV
• For best HD performance, use an HDMI cable to connect to an HDTV.
• You can also connect the ScreenPlay Director using the composite AV cable (yellow, red, and white
connectors) to connect video and audio by matching the jack colors on the TV.
• See the user's manual for other connection options (component video and optical audio).
Connecting the ScreenPlay Director to Your Network
• Wired Network Connection: Use a standard ethernet cable to connect the ScreenPlay Director to a network
router, hub, or switch. (Ethernet cable not included.)
• Wireless Network: Connect an Iomega 802.11n WiFi adapter to the host USB port on the back of the
ScreenPlay Director. (WiFi adapter not included.)
NOTE: The ScreenPlay Director cannot be connected to Ethernet and WiFi at the same time. An Ethernet
connection will provide the best results when playing videos from your network.
First Time Setup
1. Connect the power supply to the ScreenPlay Director and an uninterruptible power supply (UPS) or power
outlet.
2. Press the power button [
3. Turn on your TV and change the input setting as needed to receive input from the ScreenPlay Director.
4. When the ScreenPlay setup wizard appears on the TV screen, select the configuration options you want
to use. The setup wizard will guide you through basic settings, network configuration, scanning for TV
channels, and parental control options. If you choose to skip any configuration options during first time
setup, you can set them later using Settings from the ScreenPlay home menu. See the user's manual for
detailed instructions.
Viewing and Recording TV
You must scan for available TV channels before you can view or record over-the-air television programs. This will
take some time. You can scan for TV channels as part of first time setup or complete it later from the Settings
page on the ScreenPlay TV interface. See the user's manual for information on using the tuner functions.
Playing Media Content on Your TV
1. From the ScreenPlay home menu, select the type of content you want to play.
2. Press the Enter button to confirm your selection.
3. Select the source you want to use. The menu will list available sources, including network volumes,
connected USB devices, and folders on the ScreenPlay Director hard disk.
4. Navigate to the content you want and press the play button to start playback.
Refer to the user's manual for additional information on using your ScreenPlay Director.
2
All manuals and user guides at all-guides.com
] on the front of the ScreenPlay Director to turn it on.
Publicité
Table des Matières
