Ermax 0101P18 Serie Instructions De Montage page 2

FITTING INSTRUCTIONS
SCREEN TRIM
The trim provided
with Ermax screens
is optional.
- Heat the trim to soften the glue inside.
- Start at one end of the screen leaving a 1 cm overhang (in case the trim contracts).
The trim is only intended to cover the part of the screen which is « outside » the fairing.
- Position the trim on the edge of the screen by guiding it and pressing on the curve of the screen all
the way to the other end, leaving again a 1cm overhang. Do not stretch the trim in case it contracts as it
dries.
- Allow the glue to dry and then cut the trim to the desired length.
« CAUTION »
* Accessories gone up on the motorbike will not be any more considered as new and will be neither retaken nor exchanged.