Publicité
Les langues disponibles
Les langues disponibles
-
Firmly attach the remote control cable to the proper input on the rear of the machine.
4. Operation
-
Plug power cord into a grounded electrical outlet. Warm-up is complete when red lamp on remote units turns off.
-
To emit fog, press the button on the remote and hold for the desired length of time.
-
The remote unit's lamp will cycle on and off as the machine re-heats to the proper operating temperature.
5. Installation
The MF-700 includes a mounting bracket designed for overhead installation. This bracket allows the unit to be hung from
lighting equipment trussing or other suitable supports.
This unit can also be operated at floor level or sitting on any regular surface as well.
If the unit is to be mounted using the bracket, it is important that the fog does not shoot directly at anyone's face.
Therefore, do not point the nozzle in a direction that will aim directly at a person.
Whatever installation method you choose, do not allow the unit to have more than 15° angle of inclination.
Cleaning your fog machine regularly will help reduce costly parts replacement and repair charges.
6. Maintenance
Do not allow the fog liquid to become contaminated. Always replace the cap on the fog liquid bottle and the fog machine
liquid tank immediately after filling. After every 40 hours of continuous operation, it is recommended to run a cleaning
solution composed of 80 % distilled water and 20 % vinegar though the system to prevent the accumulation of particular
matter in the heating element.
When cleaning, use only a clean, lint-free cloth. An effective cleaning regimen is as follows :
-
While unit is unplugged and cool, unscrew nozzle at very front of the unit and clean out debris with vinegar and a pipe
cleaner, making sure that the hole is free of clogs.
-
Empty all fog fluid from machine. Add cleaning solution to tank. Plug unit in and begin warm up.
-
Run unit in a well-ventilated area unit tank is empty.
-
Replace nozzle and refill with liquid.
Important
Always monitor tank fluid level as you are fogging. Running a fog machine with no fluid can permanently damage the unit.
If you experience low output, pump noise or no output at all, unplug immediately. Check fluid level, the external fuse
remote connection, and power from the wall. If all of the above appears to be OK, plug the unit again. If fog does not
come out after holding the remote button down for 30 seconds, check the hose attached to the tank to make sure there is
fluid going through the hose. If you are unable to determine the cause of the problem, do not simply continue pushing the
remote button, as this may damage the unit. Return the unit to your dealer.
All fog machines develop condensation around the output nozzle. Because this may result in some moisture
accumulation on the surface below the output nozzle, consider this condensation when installing your unit.
Fog machines may sputter small amounts of fog occasionally during operation and for a minute or so after being turned
off.
All fog machines have a recycling period after bursts of fog when the machine will shut itself down for a short period in
order to heat up back. During this time no fog can be produced.
7. Specifications
Power : AC230V/50hz
Heater : 700W
Fuse : 250V/4A
Warm-up time : 4 minutes
Output : 2500cu/ft/ min
Tank capacity : 1 liter
Dimensions : 315 x 160 x 130 mm
Weight : 4.3 kg
All manuals and user guides at all-guides.com
Publicité
