Uline H-6438 Guide De Démarrage Rapide

H-6438, H-6439
HEAVY DUTY STATIONARY
PEDESTAL FAN
TOOLS NEEDED
Flathead Screwdriver
3-Port Electrical Chain Switch x 1
REMOVAL OF BAD CHAIN SWITCH
1. Unplug fan from power source.
2. Remove electrical box cover on motor with a 1/4" nut
driver or flathead screwdriver.
3. Remove chain switch nut with fingers or pliers by
softly turning. Save the knurled screw knob, as it may
be used during installation of new switch.
4. Using a wire cutter, cut the existing wires connected
to the bad chain switch close to the switch. This
ensures the wires are still long enough to connect
the new switch.
CONNECTING NEW CHAIN SWITCH
1. Strip about 1/4" of insulation off of wire ends for a
clean connection to new switch.
2. Connect white wire from the motor and white wire
from power cord together with a wire nut. If the
existing motor already has white wires connected,
skip this step and leave white wires connected.
(See Figure 1)
PAGE 1 OF 3
1-800-295-5510
uline.com
Pliers Wire Cutter
PARTS
Rope Pull Chain Extension x 1
INSTRUCTIONS
Knurled Screw x 1
Figure 1
Black wire
from power
cord
Blue wire from
Orange wire
motor
from motor
3. Push orange wire from motor into port number one
(high speed). It should lock into place.
4. Push blue wire from motor into port number two
(low speed). It should lock into place.
5. Push black wire from power cord to port "L" (line). It
should lock into place.
6. Reassemble fan by reversing steps #1 through #4 of
the removal instructions.
NOTE: Lines to ports one and two are
interchangeable. Ports one and two control speeds
and the above instructions explain how to wire the
replacement switch to factory specifications, but it
can be changed per user's desire.
Para Español, vea página 2.
Pour le français, consulter la page 3.
Wire Nut x 1
White wire from
motor
White wire from
power cord
0521 IH-6438