Vinten 3490-3 Mode D'emploi page 3

Introduction
1 The heavy duty Quickfix adaptor allows a pan and tilt head with a 'Quickfix' base to be installed on a
standard Vinten four-hole mounting.
WARNING!
Installation
2 Install the adaptor on the four-hole mounting using the screws provided.
WARNING!
To fit a head
NOTE: If the head does not have a 'Quickfix' base, a 'Quickfix' ring (Part No: 3101-3) is available
from your Vinten supplier.
3 Push up the red safety latch and unlock the adaptor
by pulling the lever fully outwards and to the left.
4 Position the head in the adaptor, ensuring that it seats
correctly in the recess and the safety button is
depressed.
5 Lock the head in the adaptor by pushing the lever fully
inwards to the right until the red safety latch operates.
To remove a head
6 Push up the red safety latch and unlock the adaptor
by pulling the lever fully outwards and to the left.
WARNING!
Heavy Duty Quickfix Adaptor
Maximum payload capacity 100kg (220 lb).
Do not use inverted unless a secondary anchor (such as a chain) is in use
to secure the head.
Ensure that the screws engage sufficiently for safety, but do not protrude
above the adaptor mounting face.
This unit contains a spring under tension. Removal of the backplate may
cause personal injury.
SAFETY
BUTTON
UNLOCKED
English
RED
SAFETY
LATCH
LOCKED
1