Installation And Operation - THORENS MM 002 Mode D'emploi

Installation and Operation

1. Connect your turntable to the MM 002
Plug the leads from your turntable's cartridge to the in-
put sockets on the back of the MM 002: the Right chan-
nel (red) cable into the Right input and the Left channel
(white) into the Left input. If your tonearm has a separate
earth wire for shielding purposes please connect it to
the earth binding post on the rear panel of the MM 002.
Your amplifier should be powered off or muted and
the MM 002's power supply should not yet be con-
nected.
4
2. Connect the MM 002 to your amplifier
Use high-quality RCA interconnect cables to connect
the MM 002 to an auxiliary line-level input on your ampli-
fier (Aux, Tape in, CD, Tuner, etc.).
Please ensure that the right channel output is connect-
ed to the right channel input on your amplifier, and the
left channel output is connected to the left channel input
on your amplifier.
If your amplifier is already equipped with a phono
stage and you are upgrading your system with the
MM 002, do not connect the output of the MM 002 to
the phono input: this is meant to be connected only to
a turntable's cartridge output, not to a line level output
such as that of the MM 002.