Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
ASSEMBLY INSTRUCTIONS
NOTE: The BALL BASKETS #16 & #17 have been pre-installed in table to protect them during
shipping. You may have to temporarily remove them to install the LEGS #11 as described below.
An alternative method is show in Fig. 1.
1. Attach LEGS #11 and CONNECTING PLATES #12 to the corners of the TABLE BODY as shown
below using 5/16" BOLT #1 and 5/16" FLAT WASHER #2. NOTE: the table is assembled upside down.
2. Thread one LEG LEVELER #3 onto bottom of each LEG #11. Carefully turn table upright.
#11
3. Attach BENCH SUPPORTING PLATES #15 to the BENCH ENDS #14 as shown below using
1/4" BOLT #4 and 1/4" FLAT WASHER #5.
4. Attach BENCH #13 to the BENCH ENDS #14 and BENCH SUPPORTING PLATES #15, as shown
below, using 1/4" BOLT #4 and 1/4" FLAT WASHER #5.
#15
#14
WARNING: To prevent injury, exercise caution when opening and closing bench lid. Do NOT let bench lid drop shut. Do NOT let
children operate bench lid. Be cautious when moving bench on oor. EVA pads will allow bench to slide on hard ooring,
but may cause tipping on carpeting. Lift bench ends to move.
#3
#11
#12
#12
#2
#11
#1
#8
#14
# 5
# 4
#15
Alternative Leg Attachment (Fig. 1)
# 1
1
Attach the CONNECTING PLATES #12 to
the LEGS #11 with BOLTS #1 & WASHERS
#2 through only the two inside holes of
plates as shown. Then slide this assembly
down onto table corner and secure to
table with four bolts and washers using
outer holes. Using this method will avoid
removing and replacing ball baskets.
# 4
# 5
#13
#14
Fig. 1
# 4
# 5
#14
#15
5
Publicité
Table des Matières
