Kichler 55037 Guide Rapide

Fixture Diagram
Parts List
[A] Mounting [D] Canopy
[E] Strap
Strap
[B] Outlet Box
[C] Mounting
Screws
Cautions
CAUTION – RISK OF SHOCK –
Disconnect Power at the main circuit breaker panel or main
fusebox before starting and during the installation.
WARNING:
This fixture is intended for installation in accordance
with the National Electrical Code (NEC) and all local code
specifications. If you are not familiar with code requirements,
installation by a certified electrician is recommended.
Installation Instructions
1) Attach mounting strap[A] to outlet box[B] using the
strap mounting screws[E]. Note that the mounting strap
tabs[G] should be positioned on the left and right as
shown.
2) Grounding instructions: (See Illus. a or b).
a) On fixtures where mounting strap is provided with a
hole and two raised dimples, wrap ground wire from
outlet box around green ground screw, and thread
into hole.
b) On fixtures where a cupped washer is provided,
attach ground wire from outlet box under cupped
washer and green ground screw, and thread into
mounting strap.
If fixture is provided with ground wire, connect fixture
ground wire to outlet box ground wire with wire
connector after following the above steps. Never connect
ground wire to black or white power supply wires.
a
WIRE CONNECTOR
OUTLET BOX
GROUND
FIXTURE
GROUND
DIMPLES
GREEN GROUND
SCREW
A
B
[F] Glass
[G] Mounting
Mounting Strap Tabs
Screws
OUTLET BOX
GROUND
CUPPED
GREEN GROUND
WASHER
SCREW
D
G
C
E
F
Installation Instructions (continued)
3) Make wire connections. Reference chart below for
correct connections and wire accordingly.
Connect Black or Red
*Parallel cord (round &
Clear, Brown, Gold or
Black without Tracer
Insulated wire (other
than green) with copper
*Note: When parallel wire (SPT
1 & SPT 2) are used. The neutral
wire is square shaped or ridged
and the other wire will be round
in shape or smooth (See illus.)
4) Push fixture to wall carefully aligning the mounting
screws with holes in canopy. Note: Fixture can be
mounted with glass in the up or down position. Make
sure all wires are inside canopy and do not get pinched
between wall and canopy of fixture.
5) Screw in two (2) mounting screws[C]: one on the left
side of canopy and one on the right side of canopy[D].
6) Insert recommended bulb (not supplied).
7) Carefully place the glass[F] over the socket of the fixture.
Slip the smaller opening over the socket and gently
rotate the glass until firmly seated.
b
FIXTURE
GROUND
We're here to help
Supply Wire to:
Black
*Parallel cord (square &
smooth)
Clear, Brown, Gold or Black
conductor
866-558-5706
Hrs: M-F 9am to 5pm EST
Connect White Supply
Wire to:
White
ridged)
with Tracer
Insulated wire (other
than green) with silver
conductor
Neutral Wire
IS-55037-CB