Before Installation; Installation Procedure - Wells SOPHIA Manuel D'installation

Before Installation

EN
1 Make sure the wall should be straight.
2 Read the instruction to be familiar with the tools, fittings and installation proce-
dures to prevent any unnecessary damage.
3 Check the fittings follow the fitting form and check whether there is any damage
of the product.
4 Because the ceramic is easy to be damaged, please handle it gently and the
nut should not be over-tightened.
5 Make sure water supply has been turn off.
Tools (not included)
Flat Screwdriver
Spanner

Installation Procedure

1 Put the bidet onto the suitable position, and make the water outlet of bidet
aligned with the drainage outlet.
Note : Preposition enough distance for connecting water supply pipe and drain pipe.
2 Mark the installing holes on the floor.
3 Remove the bidet carefully and drill holes according to the mark. Insert the
expansible plastics or install 7# fixing plastic.
4 Install faucet ,water supply valve and drain units according to the installation
instruction for fittings.
5 Put the bidet onto the suitable position, and get the water supply valve
and the faucet connected with soft pipe. Then adjust the connecting bar.
Note : Water faucet is not supplied with this product.
6 Get the screw aligned with the plastic particle and fix the bidet onto the floor.
Then cover the decoration cap.
7 Daub a layer of silicone between the bidet and the floor.
8 Finish the installation.
Drilling machine
Spirit level
Silica gel
Tape measure Pencil