Important Information For Initial Operation; Operation Instructions - erba 14908 Mode D'emploi

GB - INSTRUCTION MANUAL

7. IMPORTANT INFORMATION FOR INITIAL OPERATION

The product needs assembly as described below.
Installing the handle (2):
1) Insert the handle into the lifting arm and push the bolt back in from right to left. Make sure the the
hole in the middle of the bolt is not completely vertical, but tilted slightly towards you in order to
make it easier to insert the chain later (A).
2) Put the splint pin back in using a hammer to lock the bolt into place (B).
3) Lower the handle to pull the safety pin from the hydralic shaft (C)
4) Thread the chain through the hole of the bolt and attach it to the fork-shaped end of the valve
lever. (D-F)

8. OPERATION INSTRUCTIONS

The operating switch (1) on the handle (2) has 3 positions:
LOWER: for lowering the load
DRIVE: for transporting the load
RAISE: for lifting the load
If those three positions do not work properly you can adjust them by losening/tightening the screw
on the lower end of the chain (F). With the operating switch in the drive-position the valve lever
should hover 1-2 cm above the ground. The exact position may vary between models.
Refilling the hydraulic fluid (G):
Remove the screw on the hydraulic cylinder and fill the cylinder to about 3-5 mm below the
opening. Use special hydraulic oil only!
ERBA GmbH
A-1230 Wien
Talpagasse 6
Servicehotline: Tel: +43(0) 1 930 10 - 160 · Fax: +43(0) 1 930 10 - 960 · E-Mail: service@erba.at
Page 13
Changes, print, punctuation and other errors reserved!
Instruction manual
14908, 14909, 14910
Issue: 03/2021