Read Me First - Artillery Sidewinder X2 Manuel D'installation

READ ME FIRST

EN
READ THIS MANUAL COMPLETELY BEFORE
ASSEMBLING AND POWERING UP YOUR PRINTER!
HAZARDS AND WARNINGS
The Artillery Sidewinder X2 3D Printer has motorized and heated
parts. When the printer is in operation, always be aware of possible
hazards.
ELECTRIC SHOCK HAZARD
Never open the electronics bay of the printer while the printer is
powered on. Before removing the access panel, always power
down the printer and unplug the AC power cord.
BURN HAZARD
Never touch the extruder nozzle, the heater block, or the heated bed
without first turning off the hotend and heated bed and allowing
it to completely cool down. The hotend and heated bed can take
up to twenty minutes to completely cool down. Also, never touch
recently extruded filaments. The filament can stick to your skin and
cause a burn.
FIRE HAZARD
Never leave flammable materials or liquids on or near the printer when
powered on or in operation. Liquid acetone and vapors are extremely
flammable.
PINCH HAZARD
When the printer is in operation, be careful never to put your fingers in
the moving parts, including the belts, pulleys, gears, wheels, or lead
screws.
STATIC CHARGE
Make sure to ground yourself before touching the printer, especially the
electronics. Electrostatic charges can damage electronic components.
To ground yourself, touch a grounded source.
AGE WARNING
For users under the ages of 18, adult supervision is recommended.
Beware of choking hazards around children.
- 3 -