Power Setting; Temperature Setting - ALPATEC RC 20 EIT Notice D'utilisation

All manuals and user guides at all-guides.com
notice RC_20EIT:notice RC_20ET
Place the heater on a flat and dry surface and plug in it.
STARTING :
- Press the 0/1 button situated behind the product. A bip sound is emitted.
ALL FUNCTIONS ARE AVAILABLE WITH THE REMOTE CONTROL
- Press M/A button to switch on, control panel displays several patterns:
LCD shows 1000 W and
condition. If indoor temperature is higher than the set up temperature, the heater will automatically
stop blowing hot wind after about 10 seconds. The
blowing cold wind.
LCD shows the indoor temperature,
LCD shows – No flicker means no swing function.
LCD shows the «
- Press again M/A button to switch off the appliance.
- Press 0/1 button to completly stop the appliance.

POWER SETTING :

Press PUISS. button to select:
- Low power: 1000 W, 1000W and
- High power: 2000 W, 2000W and
- Fan only: nothing is displayed on G part

TEMPERATURE SETTING :

- Press MODE button.
- Set temperature flashes on H part of the display.
- The heater starting value is 25 °C. Use + and – buttons to set the desired value (from 15°C to 35 °C).
- If the ambient temperature is lower than the set temperature, the product heats. If the ambient
temperature is higher than the set temperature, the product turns to fan mode.
- Should you turn off the heater the set temperature will be remembered (except if the heater has
been completely turned off or incase of automatic security cut-off).
7/04/08 11:49 Page 12
USING
pattern is flicking : the heater starts working in low-heating
» pattern – Flicker means the anion is working.
are displayed on G part
are displayed on G part
12
pattern disappears and the heater starts