Siemens FH2072-UA Instructions D'installation

Battery housing
FH2072-UA
Installation Instructions
Instructions d'installation
EN
Mounting instructions:
1. Ensure the wall is dry, clean, flat and firm in which the controller is installed.
2. Open the battery housing using the key (5).
3. Mark the drillings for 4 mounting holes on the wall. (Fig. Dimensions).
4. Drill holes, put expansion bolts in and insert screws.
5. Break the cable entries on the housing.
6. Hang the housing on the screws.
7. Insert cables into the housing.
8. Open the battery housing using the key (5) and then tighten the screws to fix the housing on the wall.
9. Take off the battery bracket suite (6), put the battery in a proper place and then install and put back the battery
bracket suite properly to secure the battery.
10. Wire the batteries.
11. Close the battery housing and lock it using the key (5).
A6V11272329_----_b
2019-12-17
Fig. Dimensions (inch)
firealarmresources.com
A5Q00076601
Legend
1 Cable entries (4 pcs)
Battery bracket screw holes
2
(24 pcs)
Battery bracket standoffs
3
(4 pcs)
4 Mounting holes (4 pcs)
5 Battery housing key
6 Battery brackets (3 pcs)
Smart Infrastructure