FeinTech ABT00102 Instructions D'utilisation page 10

3.3 Using the receiver mode (RX)
Slide the mode switch 9 to RX. Then press the Bluetooth button twice to enter pairing mode. The RX LED will then flash
steadily and rapidly. Set your Bluetooth audio source (mobile phone, notebook, PC, etc.) to pairing mode. For Android
smartphones, you will find the function in the Bluetooth settings „Pair new device". On your iOS device, select Settings
> Bluetooth and enable Bluetooth. After the FeinTech ABT00102 is found, tap the device name to pair. The RX and A
LEDs will be lit steadily. If your audio source supports more than the standard codec, one of the Codec LEDs (LL, HD,
aptX) will also light. Then connect your audio device (HiFi amplifier, car radio, etc.) via the analogue 3.5 mm RX AUX
connector or digitally via Toslink OPTICAL. Then select the desired output AUX or OPTICAL.
If a password is requested, enter „0000", „1234", „8888" or „1111".
3.4 Multipoint with 2 phones
First, pair up the first unit as described in 3.3. Then press the Bluetooth key twice. The RX LED flashes rapidly again to
indicate pairing mode. Now activate Bluetooth on a second smartphone and search for new devices. Once the FeinTech
ABT00102 is detected, tap on this name. Now 2 sources are paired and the LEDs RX, A and B light up constantly.
Note: Only music playback from one device at a time is possible. Music from the second device is only played back
when one device is paused.
4. Bypass mode for direct connection of devices
Set the slide switch to the middle position Bypass for direct connection between inputs and outputs. Select the
desired input and output AUX or OPTICAL by pressing key 2:
ƒ When the AUX LED is permanently lit, the audio signal is routed from AUX input to AUX output.
ƒ When the OPT LED is lit continuously, the audio signal is routed from OPTICAL input to OPTICAL output.
ƒ When the AUX LED blinks once and then AUX and OPT are lit, the audio signal is converted to digital and routed
from AUX input to OPTICAL output.
ƒ When the OPT LED blinks once and then AUX and OPT are lit, the audio signal is converted to analogue and routed
from OPTICAL input to AUX output.
In bypass mode, digital audio signals can be converted to analogue or vice versa. For example, if your TV only has an
optical digital audio output, you can use the ABT00102 to convert the sound and output it through a standard stereo
system. Please note that only PCM stereo is supported. Each television offers settings in the menu for this purpose.
Please set the audio format on the TV to stereo or PCM, not Dolby Digital or bitstream.