Troubleshooting Guide - Niagara N7714TL Guide Du Produit

INSTALLATION INSTRUCTIONS (cont.)

TROUBLESHOOTING GUIDE

PROBLEM: POOR OR SLUGGISH FLUSH
Possible Cause: Water supply is blocked.
Corrective Action: Shut off water supply, disconnect supply and check water supply valve opening. (Valve is located on wall or floor).
Possible Cause:
Water level is too low in tank.
Corrective Action: Adjust water level in tank to water level mark by turning adjustment screw on top of the float arm of the
Fluidmaster
Further instructions for the Fluidmaster
valves/400a-universal-fill-valve/
Possible Cause: Water supply valve is partially closed.
Corrective Action: Open supply valve.
Possible Cause: Partially clogged trapway or drain.
Corrective Action:
Clear passage with an auger. If you are unable to clear blockage, please contact a plumber.
Possible Cause: Outlet is partially blocked by wax gasket.
Corrective Action: Lift toilet (if your toilet is a back outlet, pull from wall) and replace wax ring gasket.
PROBLEM: FILL VALVE DOES NOT SHUT OFF
Possible Cause: Water level in tank is set too high.
Corrective Action: Turn the adjustment screw counter-clockwise to lower the water level.
Possible Cause:
Debris lodged in the valve.
Corrective Action: Shut off water supply valve; remove front cap from the Fluidmaster
supply on very slowly and flush out the line.
Possible Cause: Fill valve seal may need to be replaced.
Corrective Action:
Shut off water supply; remove the front cap from the Fluidmaster
NEED HELP? Visit: niagaracorp.com/troubleshooting
WARNING
Do not place toilet bowl cleaner tablets in toilet tank. The use of these tablets in this manner may cause
leakage and void warranty.
7.
Connect the water supply to the toilet fill valve and hand tighten. Carefully connect the water
supply to the shut-off valve.
TOILET SEAT INSTALLATION INSTRUCTIONS
8.
1. Place the seat on the toilet, aligning the holes of the seat with the holes in the back of
the toilet bowl.
2. Insert the screw through the holes to secure it with the nut from the bottom of the toilet,
with the nut's tapered end on top.
3. Adjust seat position for best fit on toilet bowl.
4. Secure nut from the bottom of the toilet, use a regular screwdriver to tighten the fit.
(See picture)
5. Push the decorative cap down.
fill valve. Turn the adjustment screw clockwise to raise the water level.
TM
fill valve can be found at https://www.fluidmaster.com/products/toilet/fill-
TM
(Seat included in All-In-One units only)
valve by turning counterclockwise; turn water
TM
valve and replace the rubber seal disk.
TM