Important Safety Instructions - Velleman K8200 Mode D'emploi

Important safety instructions

CE conformity information:
The K8200 is a DIY 3D printer kit, it contains all the bits and pieces to construct your own 3D printer but does not contain
additional protection.
As it is a kit and not a finished product, compliance with the CE regulations depends on the build-quality; also the following
notes must be taken into account.
Electrical safety:
The included power supply meets all the applicable European requirements and bears the CE-mark.
It is protected against overload and short circuit and nothing needs to be modified. The working voltage of the 3D printer is
15Vdc (extra low voltage) and therefore it's outside the scope of the Low voltage directive.
!
Always unplug before maintenance or modification.
Electromagnetic radiation (EMC):
Conductive EMC towards the public distribution network is not an issue as this is related to the power supply.
Radiated EMC depends substantially on the build quality, it might be required to add shielding but this cannot be predicted.
A built K8200 should comply with EN50081 normation
VELLEMAN-KIT
3D Printer kit
Order code: K8200
manufactured by:
VELLEMAN NV.
Legen Heirweg, 33
9890 Gavere
Belgium
- 2 -