Table des Matières
Publicité
Set-Up
1. Fit the lower portion of the handle into the mounting brackets on the
cover and secure with the pins & clips.
2. Next, tighten the hose end into the gun mounted onto the upper
portion of the handle. Use teflon tape on the hose ends.
3. Once this is complete, join the two sections of the handle together
and secure with the pins & clips. Tighten the other end of the hose
into the top of the rotary head.
4. Turn the cover over and check to ensure that the nozzle tips are
securely tightened and the spray pattern is in line with the rotary
arm.
5. It is important to adjust and tighten the rotary head so the rotary
arm spray tips are a minimum of 1" distance from the surface being
cleaned.
Operation
The Surface Cleaning System you have purchased connects directly
to your high pressure hose and pressure washer by means of quick
couplers, operating to a maximum of 4 000 PSI.
This Surface Cleaner is designed to operate with both hot & cold
water pressure washers. We recommend that you supply grease to
the rotary head every 30 – 40 hours of use.
During operation, should you experience a buildup of small stones or
other foreign material within the cover, we recommend that you simply
tip the cleaner on its side at 45° which should expel any foreign
materials. This will give longer wear to your tips and rotary arm.
The tips that have been installed on your surface cleaning system
permit the use of your cleaner with a pressure washer producing up
to 5 GPM at 4 000 PSI. Higher GPM tips should be installed if your
pressure washer has a higher GPM/PSI rating. Periodically check the
tips to ensure they are not plugged by dirt particles.
It is very important when operating your Surface Cleaner, that you
maintain a continuous motion. Should you leave the cleaner in
a stationary position, the surface being cleaned can be seriously
damaged by the high pressure. The distance of the nozzle tips from
the surface can be adjusted by loosening the bolt on the rotary head
mounting collar and adjusting the rotary head up or down. Be certain
the allen head bolt is tightened again to prevent the rotary head from
moving during operation. Please ensure that your rotary head is
6
OPERATING INSTRUCTIONS
Publicité
Table des Matières
