Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
(3) Install E-e Joint pipe (A) and E-r Joint pipe (B) on E-q Stand base (R) and
E-w Stand base (L)
E-!2
•
Place the E-q and E-w Stand base as shown above and install E-e Joint
pipe (A).
•
Install right and left E-t Hexagon head bolts with washers temporarily.
•
Place the E-q and E-w Stand base as shown above and install E-r Joint
pipe (B).
•
Install right and left E-y Hexagon head bolts with washers and E-u
Hexagon nuts temporarily.
•
Tighten the bolts and nuts with E-!2 S panners.
(4) Install E-i, E-o Double-wheel caster
•
Tilt the stand as shown above and insert E-i, E-o Double-wheel caster into the
holes in the bottom of the stand bases (R) and (L), and tighten them with E-!3
Spanner for casters.
There are two casters with stoppers and two casters without stoppers.
Install them at the locations shown in the figure above.
Move : raise the lever.
Fix: Push the lever down.
All manuals and user guides at all-guides.com
E-r
– 7 –
E-w
E-y
E-e
E-u
E-i,
E-!3
E-o
E-q
E-t
Up: Move
Down:
Fix
Publicité
Table des Matières
