Publicité
Les langues disponibles
Les langues disponibles
Fitting kit
- 2 fitting brackets
- 2 Ø5 plastic washers
- 2 BHc 5x15 screws
- 2 Ø6 rubber washers
Assembly
- Remove the original chain guard and keep the screws.
- Position the brackets on the right side of the swinging arm by inserting the flat bracket inside the
arm. Then circle the arm with the other bracket.
- Place the rear hugger on the motorbike. Fit the chain guard side with the original screws and
provided washers, and the other side of the hugger on the bracket thanks to the provided screws and
washers. Check the hugger centring before tightening.
* Painted and varnished parts are not guaranteed against high pressure steam washes or aggressive cleaning products which can damage them and unstuck the varnish. We advise moreover, according to the technical data of our
painting suppliers, to wait one month to obtain a complete polymerization of varnish.
* Accessories gone up on the motorbike will not be any more considered as new and will be neither retaken nor exchanged.
* Ermax accessories are foreseen for original equipments. They will not be guaranteed if they are used in others conditions.
* Due to vehicles made tolerances, beyond our control, some Ermax products might need adjustings to fit.
* A few tyres, faithful to ETRTO standards, may be in fact bigger and higher than dimensions engraved on the tyre (until + 10 mm). They may be not compatible with undertrays and rear huggers which we made with original
tyres and whose dimensions correspond to these ones engraved on tyre.
* Harden the rear shock absorber while drivings with load or on dented roads.
* Care to excessive clampings which may damage or break our plastic accessories and aluminium screws.
* The mentioned label of motorbikes's manufacturers are indicated exclusively as a reference to Ermax accessories.
ADAPTABLE ON ZR7 1999/2003
«
»
ATTENTION
FITTING INSTRUCTIONS
ERMAX REAR HUGGER
Original tyre 160/60 ZR 17
Publicité
