Anti-Skating Control; Operation; Drive Belt Assembly - Audizio RP340 Manuel D'instructions

CAUTION! Immediately upon receiving the product, carefully unpack the carton, check the contents to ensure that all parts
are present, and have been received in good condition. Notify the shipper immediately and retain packing material for
inspection if any parts appear damage from shipping or the package itself shows signs of mishandling. Save the package and
all packing materials. In the event that the product must be returned to the factory, it is important that the product be
returned in the original factory box and packing.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately.
The arising condensation water might damage your device. Leave the device switched off until it has reached room
temperature.
1. 45rpm adapter for 7" vinyl record
2. Counterweight
Used to level out the tone arm.

3. Anti-skating control

The anti-skate feature applies a small outward force to
the tonearm, counteracting the tendency of the arm to
move inward (skate) toward the center of the record,
as the tonearm approaches the end of the record.
4. Lift lever
Operate to lower or raise the tone-arm.
5. Tone-arm clip
This specially designed arm clip secures the tone-arm
while at rest or when not in use.
6. Pitch control
Turn to adjust the speed of the platter little by little.
7. Speed button
This switch controls the RPM (33/45rpm) of the record
player platter.
8. Headshell
9. Mode switch
Switch to select phono- or line-out -mode.
10. RCA line output
Line signal RCA connectors to connect the record
player to a mixer or an amplifier.
11. DC input
Connect the power adapter.
1. Remove the needle protector carefully.
2. Set the anti-skating control at 0 (zero).
3. Push the lift lever in the down position
4. Release the tonearm from the clip and position it in the free space between the platter and the tonearm rest/clip.
Note: be careful not to damage the needle.
5. Hold the tonearm at the headshell and level it by turning the counterweight to the left or to the right. The adjustment is
done correctly if the tonearm is parallel to the record above the platter and does not lean towards counterweight- or
headshell side when released.
6. Place the tone arm on the tone arm rest and secure it with the clip.
7. Keep the counterweight in the set position. Turn the scale ring until the 0 mark is in line with the mark printed on the axis
of the tone arm. The zero base setting has been determined.
8. Turn the scale ring to correspond to the characteristics of the used cartridge. If the provided cartridge is being used, the
scale ring must be adjusted to 1.5 - 2.5 grams.
.
5