Audizio RP330 Serie Manuel D'instructions page 5

CAUTION! Immediately upon receiving the product, carefully unpack the carton, check the contents to ensure that all parts
are present, and have been received in good condition. Notify the shipper immediately and retain packing material for
inspection if any parts appear damage from shipping or the package itself shows signs of mishandling. Save the package and
all packing materials. In the event that the product must be returned to the factory, it is important that the product be
returned in the original factory box and packing.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately.
The arising condensation water might damage your device. Leave the device switched off until it has reached room
temperature.
1. Platter
Place your record here.
2. Slip mat
3. Lift lever
Push the lift lever backwards to be able to raise the tone-
arm. Gently move the tone-arm to the desired position
over the record. The platter will begin to spin when the
arm is moved towards the record. Push the lift lever
forwards to be able to lower the tone-arm slowly onto the
desired position on the record to begin playing the
record. Please note: The record will only begin to spin
when the tone-arm is moved towards the record if the
Auto Stop function is turned on.
4. Tone-arm clip
This specially designed arm clip secures the tone-arm
while at rest or when not in use. The arm clip has been
designed to remain in the up position while unlocked.
5. Autostop Switch ON/OFF
This switch turns auto stop on or off. When the automatic
stop is enabled, the platform will start rotating as soon as
the tone arm is placed over the record and will stop
rotating when it has reached the end of the record. Some
vinyl records stop before the end or do not stop when the
end is reached. In this case set Auto-stop function to OFF.
6. Speed button
This switch controls the RPM (33/45/78rpm) of the record
player platter.
7. Platter shaft
8. Tone arm
9. Status indicator
10. Volume control knob
Turn the knob to set the volume of the record player.
11. Cartridge with needle
When the record player is not in use, it is recommendable to place the removable protection cover over the stylus.
12. External speaker output
13. Mode switch
Switch to select phono- or BT-mode.
14. RCA line output
The sound signal from long-playing record is sent to this line output. Connect this signal to the line input of an such as an
amplifier or a line input of a CD/DVD player.
15. DC input
Connect the power adapter.
16. Power ON/OFF button
Push the Power On/Off button on the unit to turn on/off the record player.
17. Speaker input connector
Connect the external speakers to the record player by using the supplied speaker cables (red cable to red connectors; black
cable to black connectors). Firmly and securely insert the DC plug of the power adapter in the DC input connector on the back
of the record player.
5