Publicité
Les langues disponibles
Les langues disponibles
1074, Avenue des Carrières – Z.A la Plaine du Caire III
13830 ROQUEFORT LA BEDOULE – FRANCE
www.ermax.fr - E-Mail : accueil@ermax.fr
Fitting kit
- 1 piece of foam 20x10x3
Fitting instructions
- Remove the original chain guard and both clips securing brake hose.
- Place Ermax rear hugger. Fit it thanks to the original screws : take care the front fixation of brake hose is fitted
over the rear hugger and the foam is placed between the back of the hugger and the swing arm (see photo
below).
Brake hose fixation
- Tighten the screws once the rear hugger is well centered.
* Painted and varnished parts are not guaranteed against high pressure steam washes or aggressive cleaning products which can damage them and unstuck the varnish. We advise moreover, according to the technical data of our
painting suppliers, to wait one month to obtain a complete polymerization of varnish.
* Accessories gone up on the motorbike will not be any more considered as new and will be neither retaken nor exchanged.
* Ermax accessories are foreseen for original equipments. They will not be guaranteed if they are used in others conditions.
* Due to vehicles made tolerances, beyond our control, some Ermax products might need adjustings to fit.
* The mentioned label of motorbikes's manufacturers are indicated exclusively as a reference to Ermax accessories.
* Care to excessive clampings which may damage or break our plastic accessories and aluminium screws.
* A few tyres, faithful to ETRTO standards, may be in fact bigger and higher than dimensions engraved on the tyre (until + 10 mm). They may be not compatible with undertrays and rear huggers which we made with original
tyres and whose dimensions correspond to these ones engraved on tyre.
* Harden the rear shock absorber while drivings with load or on dented roads.
ADAPTABLE ON BMW F 700G S & F 800 GS 2013 → ∞
Foam
« CAUTION »
FITTING INSTRUCTIONS
ERMAX REAR HUGGER
Estimated fitting time : 20 mn
Publicité
