Publicité
establishing a wired connection
Press the
button several times until you select the auxiliary source.
1.
Plug the 3.5 mm audio connector into your audio source, such as an MP3/MP4 player
2.
or a laptop, for example...
Plug the other end of the cable into the radio's AUX IN auxiliary input connection.
3.
Begin playback and adjust the volume on your audio source.
4.
plug in a removable device
Plug in your USB fl ash drive or insert your micro SD card into the ports on the back of
5.
the radio.
Press the
button several times until you select the USB or SD source.
6.
Playback will begin automatically. Press the
7.
button to reduce the volume.
Turn the settings knob to the left to access the previous track or to the right to access the
8.
following track.
Press the
button to begin or pause playback.
9.
54
V.1.0
button to increase the volume or the
troubleshooting guide
SYMPTOMS
POSSIBLE CAUSES
The appliance is not plugged in.
The radio does
not switch on.
The mains socket has no electricity
supply.
The volume is set to the minimum.
No sound.
The source selected is not correct
The radio is not operating normally or is
Malfunction.
emitting an unusual sound.
The aerial is not fully extended.
Poor
There is interference from other
FM reception.
electrical appliances (microwave, TV,
etc.)
The aerial is not fully extended.
Poor
DAB reception.
Your region is not covered by DAB.
The playback format is not supported
No playback via
by the radio.
a USB fl ash drive
or an SD card.
Check that the USB fl ash drive or the SD card are correctly plugged into the
USB port or the card reader on the back of the radio.
Your audio source is not in pairing
The Bluetooth*
mode.
connection
*
cannot be
Make sure that the radio and your Bluetooth* appliance are less than 8 metres
established.
apart and that no walls or electrical appliances are disrupting transmission.
SOLUTIONS
Plug the appliance's adapter into a
mains socket.
Plug another appliance into the same
mains socket to carry out a cross test.
Adjust the volume by pressing the
button or the
button.
Select the appropriate source by
pressing the
button.
Unplug the appliance for 30 minutes.
After 30 minutes, turn the appliance
on again.
Arrange the aerial.
Move your radio away from any
sources of interference.
Arrange the aerial.
Check your region's DAB coverage.
Check that the music has been
correctly recorded in the removable
media, in MP3/APE/FLAC/WMA
format.
Consult your audio source's user
manual for more details.
55
V.1.0
Publicité
